Looking for:
Safety first 3-in-1 car seat manualSafety 1st 3-In-1 Owner's Manual.Safety first 3-in-1 car seat manual
Replacement Parts List. NOTE: If requested color is not available, similar color will be. Quantity Total Cost. Harness Strap. Pad Set. Harness Retainer. Locking Clip.
Tether Kit. Latch Kit. Shipping and handling:. Indiana, California, and Massachusetts residents add applicable sales tax. No shipping and handling on instructions for quantities under 6. Fill Out For Credit Card. Card Exp. Failure to follow the warnings on the labels. Previous Page. Next Page. Car Seat Safety 1st alpha omega elite Instruction Manual 33 pages. Car Seat Safety 1st Alpha Omega Elite Installation Manual Rear-facing child restraint, forward-facing child restraint, belt-positioning booster 33 pages.
Car Seat Safety 1st onBoard 35 Manual 29 pages. Car Seat Safety 1st onBoard 35 Manual 32 pages. Thank you for choosing this car seat, referred to throughout this manual as a child restraint. The DJG family is committed to creating a child restraint with the most comfort and convenience available today. Dorel Juvenile Group does not recommend the use of any child restraint accessories except those recommended by DJG. This will increase comfort and allow the harness to properly tighten.
Determine which of the three available buckle slots is both comfortable and snug. Remember to always pull up on harness straps to make sure buckle is locked tightly. Press red button on buckle to release the buckle plates. Push down on harness release button while pulling up on harness straps above the latch plates to loosen. After tightening the lap belt securely, tilt and push the child restraint forward and to both sides.
Rebuckle belt. Lap belt portion should now be tight. If not, remove locking clip and repeat all steps. You may need to remove the base for narrow vehicle seats or airline use. Pull up on shoulder strap to remove any slack. NOTE: In some cases, you may need to pull the pad off Hide thumbs.
Table Of Contents. Quick Links. Table of Contents. To see installation videos, scan the QR Code. Failure to follow the warnings on the labels and in the. Previous Page. Next Page. Car Seat Safety 1st onSide air User Manual Convertible car seat rear-facing pounds 19"" forward-facing pounds 34"" 31 pages. Car Seat Safety 1st Chart air 65 Instruction Manual Air protect convertible child restraint rear-facing pounds 19"" forward-facing pounds 34"" 33 pages.
Car Seat Safety 1st alpha omega elite Instruction Manual 33 pages. Please talk to your doctor about the best option for your child. Or the buckle tongues can be Fully Loosen Harness placed into the slots in the harness Straps holders as shown. Changing Position of Buckle Use the guidelines below to determine if the buckle and harness strap Unbuckle Harness are in the right place for your child.
Page Reclining Child Restraint Reclining Child Restraint Check Harness Tightness This child restraint has 3 positions: Try to pinch the harness at the shoulders vertically between index Rear Facing - 3 or 2 finger and thumb as shown.
For children who cannot sit up unassisted, the level line on shell If your fingers slip off, the MUST To remove accessories, see page Unbuckle Harness Press in towards the top of the red button.
Pull up to remove completely. If you will be using the lower Pull out of slot in shell. The cupholder is dishwasher safe. Page Child Restraint Use Vehicle Seating Position Child Restraint Use Never place a child rear facing in a seating Never take your child out of the child restraint while the position with an active frontal air bag.
Please follow the following steps to under- stand how to lock a child restraint with a vehicle belt. Use only if the belt can be tightened properly and securely. For children who cannot sit up unassisted, the level line on shell The lower anchor belt adjuster MUST be parallel with the ground. Remove tension from the lower anchor Push and pull from side to side. Secure For children who cannot sit up lower anchor hooks to storage unassisted, the level line on shell attachments as shown when install- MUST be parallel with the ground.
Belt Path Push and pull from side to side.
No comments:
Post a Comment